#6 X 3/8" Type A Self Tapping Sheet Metal Screws | Oval Undercut Head | Phillips Drive | Steel Zinc & Bake (10000/Pkg.)

Type A Self Tapping Sheet Metal Screws are designed for fastening into thin to moderate gauge sheet metal without extensive pre-drilling. The oval undercut head and Phillips drive provide flush seating and reliable torque transfer in metal assemblies.

Specs

• Diameter: #6
• Length: 3/8 inch
• Finish: Zinc & Bake
• Drive type: Phillips
• Material: Steel

Features

• Self tapping capability: Cuts its own threads in thin sheet metal, enabling rapid installation with minimal pilot hole requirements.
• Oval Undercut Head: Sits flush against the workpiece to minimize protrusion and provide a clean finish on panels and enclosures.
• Phillips Drive: Broad compatibility with standard power or hand drivers; reduces cam-out risk on soft metals.
• Finish: Zinc & Bake plated; provides corrosion resistance and extended service life in indoor environments.
• Material: Steel; zinc-coated for sacrificial protection and ease of fastener replacement in assemblies.
• Application range: Suitable for automotive interior trim, electrical enclosures, metal cabinets, HVAC ducting supports, and appliance housings where sheet metal fastening is needed.
• Installation tips: Use pilot holes if recommended by gauge thickness; ensure adequate thread engagement for load requirements; apply torque within spec to prevent screw head damage.